Laminate

You can either measure your cabinets or existing countertop. Always measure the outside dimensions from one back corner to the other back corner.

Yes, please note all sink and appliance locations as well as any exposed ends. Note brand and model number when cooktops or cutouts are needed within the design to ensure a proper cut.

Printed representations of the colors may differ from the actual samples. It is always best to view a sample in your space and light for proper representation of the color. Take home boards are available for check out in all Menards^® stores, in addition, samples can be ordered of all materials on www.menards.com.

Yes, however there are limitations based on your layout. A Menards^® Team Member can help you plan accordingly.

Yes, however there are limitations based on the material chosen. Laminate would need to have a self edge. Solid Surface^TM and Quartz^® can be made in out of square layouts in all edge profiles.

Any sink, appliance or cuts with under 24" remaining material are considered scrap and will not ship with the order.

We offer four wrap style edges, four standard edges and two specialty edges. Styles include Ogee full wrap, Aurora, Marquis, European, Ogee, Principal, No-Drip, Modern, Self Edge styles.

Due to postformed nature of laminate countertops if a countertop design requires a profiled edge along both the front and ends of a design it will only be available in self or beveled edge styles.

End finishes offered include profiled, end cap applied and straight cut. Profiled ends allow the same edge profile as the front edge of the top to wrap around to an exposed end, but are limited to Self Edge styles. End Cap Applied is a straight cut end with a laminate end cap running the length of the cut. This is ideal on the ends that are exposed into a room or next to an appliance such as a stove or refrigerator. Straight Cut ends are cut and uncapped. These are commonly used where the edge will not be visible such like where an end butts up against a wall.

Factory installed undermount sinks offer a smooth transition from the countertop to the sink with no lip for water or dirt to build up. These sinks are installed at the factory for a quicker installation of your top.

Stainless Steel, Quartz and acrylic. Please note, acrylic sinks are not recommended for use with garbage disposals.

No the faucet holes will need to be cut on the job site per the installation instructions. Laminate Faucet Install Guide

No, miter angles available are 45 or 22.5 degrees.

Wash the surface with mild dish washing detergent liquid or a powdered detergent; add warm water and wipe with a soft dish cloth. Rinse with warm water and dry with a soft cloth. This is generally all that is needed. For stubborn spots, make a paste with baking soda and water. The paste will be slightly abrasive. Work carefully to keep from damaging the surface you are cleaning. Dip a soft bristle brush into the paste and cover the bristles. Gently rub the spot with the brush, moving in a circular motion and pressing very lightly. You may also use magic eraser stain remover following the manufacturer's instructions for stubborn stains. Please note: DO NOT use cleaners that contain harsh acids or abrasives, like but not limited to, bleach.

No, avoid cutting directly on laminate countertops, always use a cutting board.

You can order up to 60"x144" in Self Edge only.